I'm currently re-wiring my 96 jagstang (it's been out of commission for way too long) and I'm stuck.
Here is the back of the scratchplate:
and here is the control plate:
I was wondering if anyone would be able to "fill in the blanks" as it were.
I'm not sure I've wired up the humbucker correctly. There are 2 wires, I assume one is the hot and one is the ground. Are both wires soldered to the pickup selector, or just the hot (with the ground getting directly soldered to the ground in the humbucker cavity)?
Secondly, does the control plate wiring look correct? Should there only be one wire connecting the volume pot and the pickup circuitry?
Is there anything else amiss you can spot? I was just going for emulating the stock wiring as much as possible. Apologies if this has been covered before, I tried searching the forum but couldn't find what I was looking for. Also, sorry if this is ridiculously simple, I'm crap at reading schematics.
Any help would be really appreciated.
Many thanks!
Mike
