completely forgot about this, and dont have the time to do it today, so heres a schematic: http://www.seymourduncan.com/support/wi ... ematic=ssp that diagram will work, just replace:
white with the bridge pup negative
red with the neck positive (take wire from on/off switch to bass cut switch, and run the wire from where black would go to the on/off switch)
dont touch the bridge hot wire (which goes to the switch to turn it on) or the neck negative (grounded) wire.
works best with single coils where the ground and negative wire are seperate, otherwise, youll get increased noise, and lots of it if you touch the bridge pup. try it out and if you like it, take it to a tech and tell him to seperate the negative from the ground on the bridge pup.
