hot and ground?

tylerfender

On a jagstang, where do i solder the red wire(hot) and the green and bare wires(ground) for a humbucker? anyone have a diagram? the original js pup was only 1 wire.

tylerfender

got diamrzio super distortion wired, turns out the neck pup switch is bad, so i had to replace it, now wiring the thing is confusing. 😵

jacksonjackass

If you can wait till sarturday, I'll draw you up a diagram in paintbucket 😉

tylerfender

ok.Thanks. Ive been studying the schematic but the bridge pup switch isnt wired how its supposed to be, i dont think. And ive wired the neck switch up exactly how it is on the schematic but all i get is fuzz when i touch the neck pup. u know, the zzzzzzzzzz sound when i touch the poles of the neck pup.

JaguarOW

put ground wires on the back of one of the pots and i think it will work

tylerfender

JaguarOW said: put ground wires on the back of one of the pots and i think it will work

do you mean pots or switches? cuz i have ground wires on both the switches. And, i havent touched the pots, except to add an orange drop.

jacksonjackass

Just look where the original hot and ground wire went. Usually on four conductor pickups, you solder 2 wires together, two go to hot and then there is a ground wire

tylerfender

got it fixed now. 😁