Is there a way to use one slider switch as a 3-way toggle and disconnect the other?

DavyD

I'd much rather just have a LP type toggle but use just one slider. I'm totally new to modifying my guitar wiring but good enough with tools and learning to get the job done. I have seen the alternate mustang schematic on this site but am wondering if it can get simpler yet without routing the body. Thanks!

HNB

Davy D said:
I'd much rather just have a LP type toggle but use just one slider. I'm totally new to modifying my guitar wiring but good enough with tools and learning to get the job done. I have seen the alternate mustang schematic on this site but am wondering if it can get simpler yet without routing the body. Thanks!

The alternative diagram would work. Just have the "out" from the slider go to the volume pot and leave the other one not connected to anything.

DavyD

HNB said:
The alternative diagram would work. Just have the "out" from the slider go to the volume pot and leave the other one not connected to anything.

OK cool thanks. I'll have time to think about what to do since I'm waiting on my new neck pickup, wiring and the switches, bridge and tailpiece will be here from Warmoth tomorrow. Neck just got purchased on ebay today from a 65 model (think its from a Jag since it says "contoured body" on it.