If this is for the special HH (CIJ/MIJ model), it's identical to a regular Jaguar, just with Humbucker pickups in it (2 conductor at that which are no different than single coils).
What you need to Wire a Jaguar, if you want to assemble them yourself....
- 3X SPST 2-way Slide Switches (Pickup On/Off, and Strangle)
- 1X DPDT 2-way Slide Switches (Rhythm/Lead Switch, you can also just use 4 of these instead of the above to do the STrangle & Pickup On/Off Switches for the lead circuit, Fender did that with the CIJ Jaguars like mine)
- 1Meg Ohm Audio Taper POts (Lead Circuit Volume and Tone)
- 1Meg Ohm LInear Taper Pot (Rhythm Circuit Volume)
- 50K Ohm Linear Taper Pot (Rhythm Circuit Tone Pot)
- 1/4" Phono Jack, Mono (output Jack)
- .01 Microfarad (mfd) Capacitors (Tone caps for Rhythm and Lead Tone pots)
- .003 PicoFarad (pfd) Capacitor (Strangle Switch)
- Approximately 6-8 Feet of either pull-back cloth shielded cable (for a early-60's wiring job) or PVC covered wire (for a 65' and later wiring job). You can go color coded or do what I do and use one color. Color Coded is factory correct though.
