I’ve got a ‘64 mustang that I’ve had for 35 years. As a teenager we decided to move the output jack to the body edge and drilled (I use the term loosely) a hole for it and stripped the “cracked” paint off. Needless to say it’s sat in parts in the case all this time. I recently repainted it, cleaned up the drilled hole, and am almost ready to do the wiring. Only one original pickup was good so I’ll be using SD SSL-5’s with one being RWRP. Output jack will remain on the body edge and a 3 way toggle pickup selector will go on the control plate where the jack originally was. I ordered a new pickguard for it and left the slide switch holes like original. I was wondering if some of you experts could look over the following doodle to tell me if this would work for the wiring?