Jump to content

Search the Community

Showing results for tags 'cigar tube'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Guitar Discussions
    • Fender Jag-Stang Discussion
    • Fender Jaguar/Jazzmaster Discussion
    • Fender Mustang Discussion
    • All Other Guitar Models
    • Effects, Pickups, Amps, Setups, Etc...

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 1 result

  1. I couldnt find a decent video or forum post anywhere so i decided to post this and figure it out as i went along. you may ask why do this mod? increased sustain was what i was after and i was shocked to find it greatly increased after this mod. the hardest thing about this whole mod is removing the tremolo springs... i used a flat head screw driver and needle nose pliers for that. we will talk about washer sizes later in the post. things you will need : new strings, possibly needle nose pliers, 4 metal washers, philips head screw driver (5/32), flat head screw driver(any size) hex wrench (3/32) first start by removing all screws... ignore the two spring post in the photo This is where the hard part comes in. my only advice is using a flat head screw driver and pry them off the posts that way. or if you have no need for them ever again, use a saw or file to cut the springs off Here is everything you will need for the next step. i cannot stress this enough that you will need 4 washers, two on each post that used to connect the springs. one on each post isnt sufficient and will result in an non stable, still moving back and forward cigar tube. now put the posts back where they belong on the plate and add two washers on each post. washer size isnt important as long as they fit over the post and dont leave too much wiggle room between post and washer. at this point you will attach the cigar tube to the post. you will want to flip the tube in a way you can sting through the tube instead of having to wrap strings around it. the washers sit under the cigar tube and above the plate. so in between the two. you will use your hex key to tighten the posts to the tube and this will lock them tight and there will not be any movement what so ever! now you can put the unit back in place, attach it back to the body with your screws. strings will go through the tube like so. A side view of what it looks like between the bridge and cigar tube
  • Create New...