Search the Community
Showing results for tags 'phasein'.
Hello all. I'm hoping for some wiring assistance. Here's the scoop: CIJ RI Fender Mustang. 2004 approx. Current pups are single coils, don't think they are stock though. I am the second owner, looks like previous owner installed staggered single coils (brand unknown, both neck & bridge read 5.8K on the back of the pup). I am replacing the bridge pickup with a Seymour Duncan Lil' Screamin' Demon single-coil sized humbucker. I also picked up CTS 500K pots (audio taper). One of them is push/pull. The tone cap I have to install is .022uF. I am looking to wire it for the following switch settings: (headstock------tailpiece) -0- -0- both pickups off -0- 0-- bridge on (forward) -0- --0 bridge on (back) 0-- -0- neck on (forward) --0 -0- neck on (back) 0-- 0-- both pups on, in phase --0 --0 both pups on, in phase 0-- --0 both pups on, out of phase --0 0-- both pups on, out of phase My aim is to have the push/pull as the tone pot. Pushed in, humbucker, pulled out single coil. So for the aforementioned settings, the settings with both pickups would be bridge as humbucker when pushed. Then bridge as single coil when pulled. And with the bridge-only pup setting, the same push/pull controls. I want the out of phase settings to be humcanceling, regardless of humbucker/single coil push/pull. Is this possible? I can't seem to find a wiring diagram for this specifically. Does anyone have a simpler idea to achieve these (or comparable) settings? Thanks!