Jump to content

Search the Community

Showing results for tags 'seymour duncan'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Guitar Discussions
    • Fender Jag-Stang Discussion
    • Fender Jaguar/Jazzmaster Discussion
    • Fender Mustang Discussion
    • All Other Guitar Models
  • Other Discussions
    • Effects, Pickups, Amps, Setups, Etc...
    • Trading Post

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 5 results

  1. Hello! When i removed the bridge of my jaguar I found a surprise. how can i remove the rust without ruining the paint? Bo
  2. So, I am trying to build a mustang with the same specs that Kurt's had at the 1993 show at the Roseland Ballroom. I was wondering if he used at JB JR, Hot rails or did he just use a JB Humbucker?
  3. Hey all, I've had my HH Special for a few years now, and I love everything about it, except for the lack of clarity in the pickups. So I've bought a set of Seymour Duncan 59/Custom Hybrid humbuckers. Only issue is, the Fender Dragster pickups that were in the guitar have a thick cable which terminates by splitting into a single output wire, and a bare ground wire. Whereas the 59s terminate by splitting into a red, white, green, black and bare wire. Do I need to just solder together and tape off some of them? Also, the Dragsters are soldered to their pickup covers, but the 59s do
  4. Hi, First post on here but have had some helpful tips from you lot in the past. So i've got a fender jag MIJ 1994 and have recently upgraded the pickups to Seymour duncan quarter pounders, both neck and bridge. I installed them and both worked fine for about a month but now the neck pickup has stopped working properly. With the top switch in 'lead' position the neck pickup is super quiet. With the top switch in 'rhythm' mode the neck pickup is silent. The bridge pickup is still nice and loud. Is this a pickup fault? I've re- soldered the wiring but still no good. Any help much apprecia
  5. Long story shor: I was replacing the stock "Duncan Designed" pickup covers and switching them for Fender Aged White ones. To my surprise the stock pickup covers were glued on. The neck pup cover came off without too much trouble, however, the bridge pup was damaged in the process. I took it to my local tech and he says the coil is damaged and recommends getting a new pickup vs rewinding them. Honestly the stock bridge pup (Model JM-101B) was just a little to shrill for my personal taste. I could get an ok tone when rolling the tone knob down but then switching between pickups is a pain in
×
×
  • Create New...