Jump to content
Sign in to follow this  
Nicolas

help, check this !!

Recommended Posts

Nicolas    0

why is the tailpiece totally straigh on my jag-stang, but visibly angled ( toward the bridge direction) on my mustang ? ??

dsc01073nt9.jpg

dsc01074fl7.jpg

Share this post


Link to post
Share on other sites
Nicolas    0

bah no, i removed the ''metal plate'' to take a look, and the springs are in good condition, theres a lot of tension.

i even wonder if theres too much tension on the metal plate, after all only a couple of screws are holding it on the body of the guitar.

Share this post


Link to post
Share on other sites

Hmmm, well maybe the tailpiece poles need to be lowerd some, they do look a little high compared to the ones on the Jagstang. And as long as you have all 5 screws in the bridge plate, it should be fine.

Share this post


Link to post
Share on other sites
Nicolas    0

hum yes, the tailpiece on my jagstang is lower, we can even notice it on the pics i posted,

i got the right allen key, ill try to lower it a bit.

Share this post


Link to post
Share on other sites

Or what you might have to do is, lossen the strings, pull the plate, unhook the springs from the poles, lower the with them with your fingers, rehook the springs, i think there is two slots in which the spring could go, use the lowest setting if not already there, the tailpiece the should have alot on tention on it, holding it in place leaning towards the back of the plate, reassemble, restring/tune. The tailpice should only raise a little, I have all mine slightly leaning back on all my Stangs. And this is the procedure i did to ajust it.

Share this post


Link to post
Share on other sites
Nicolas    0

earlier, when i pulled the plate out, i noticed there was 3 slots in which the springs can go, and the springs were settled on the higher ones,

so i think this is my prob,

wait a minute, ill take it out again and post a pic

Share this post


Link to post
Share on other sites
Nicolas    0

ok look

dsc01077gh4.jpg

so where should i set the springs ? in the middle ? or in the lowest position ?

also, it doesnt seem easy to unhook the springs, they are quiet rigid

edit: actually, the position of the springs is not the problem. i removed the plate on my jag-stang also, and it is set the same way.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×